28 Hold-o-mat
®
– Instructions de service
Travaux à effectuer avant la première mise en service
Directive du service
après-vente
Veuillez par conséquent ne placer aucun support de données magnétique
(disquettes, cartes de crédit, cartes chèque, cartes d’identité avec bande
magnétique, bandes magnétiques) ni aucune montre à moins de 0,5 m
de l’appareil.
Attention: champ
magnétique!
Si le technicien de service après-vente est porteur d’un accessoire cor-
porel actif (pacemaker par exemple), il devra se tenir à au moins 0,5 m de
l’appareil. Les personnes porteuses d’un accessoire corporel actif (pace-
maker par exemple) ne sont pas autorisées à utiliser l’appareil. Il incombe
par ailleurs à l’exploitant de veiller à ce que ces personnes ne soient pas
à moins de 0,5 m de l’appareil.
Changement du sens
d’ouverture de la porte
Découpler la porte pour changer le sens de son ouverture est facile et ne
prend que 10 à 15 minutes. Du fait que pour cela, le carter de l’appareil
est retiré, les pièces conductrices de courant ne sont plus protégées.
La porte doit par conséquent obligatoirement être découplée par un
technicien compétent (électricien agréé, monteur de service, vendeur
habilité par Hugentobler SA) et ce, en respectant les directives du service
après-vente.
Débrancher la fiche de secteur de la prise. Débrancher la prise de l’appa-
reil de la fiche de la commande. Ranger – pour toute la durée des travaux
de service après-vente – le cordon d’alimentation dans un endroit non
accessible à d’autres personnes. Dévisser les deux vis de l’ancrage de
porte (en bas) puis décrocher la porte. Dévisser la/les vis qui se trouve/nt
en face de l’ancrage de porte (411: 2 vis supplémentaires, sous le carter).
Dévisser les 6/8 vis placées au dos de l’appareil et qui assurent la liaison
entre le carter de l’appareil et le panneau arrière.
Faire glisser le carter vers l’arrière puis, au niveau de la partie avant, pous-
ser légèrement en arrière l’isolation principale afin de permettre l’accès
aux deux plaques arrières sur lesquelles sont fixés les quatre aimants. Dé-
monter ces deux plaques puis les remonter sur le côté opposé. Ramener
en avant l’isolation principale et le carter de l’appareil. Revisser ferme-
ment chacune des 6/8 vis sur le panneau arrière. Bien visser la vis qui, à
l’avant et en bas, maintient le carter. Retirer l’axe supérieur de l’ancrage
de porte puis l’installer sur le côté opposé.
Retirer les capuchons qui se trouvent à l’intérieur de la porte, sur le côté
de celle-ci où sont montées les douilles d’ancrage de porte. Retirer les
capuchons placés sur le petit côté de la porte. Avec un tournevis cruci-
forme adéquat, faire sortir les douilles de leurs logements puis les monter
sur le côté opposé. Remonter les capuchons de la face intérieure et du
petit côté de la porte. Ne pas monter la porte à l’envers car cela nuirait à
l’efficacité de la fente de déshumidification. La poignée de la porte doit