Respironics SmartMonitor2, Operator'S Manual

Page: 62 / 80

Transferring SmartMonitor 2 Information
56
Transferring SmartMonitor 2 Data to a Memory Card
The Memory Card is a credit-card-sized electronic memory transfer device that transfers monitor data.
This is an optional feature of SmartMonitor 2 and may not be installed on every unit.
All data in the memory card at the time of a download will be overwritten. For more information refer
to Setting Alarms and Recording Limits section of this manual
M
em
or
y
Ca
rd
Push button
to remove
Memory Card
Memory Card
M
em
or
y
C
ar
d
INITIALIZING
PLEASE WAIT
The illustration above is a close up of the LCD
display on the bottom of the SmartMonitor 2.
When you are ready to use the Memory Card to
transfer SmartMonitor 2 data, follow the steps below:
1. Make sure the SmartMonitor 2 is
off .
2. With the Memory Card facing you slide the card
into the slot provided on the side panel of the
SmartMonitor 2. The location of the memory card
logo will be on the bottom edge and facing you.
(See illustration).
3. Press the POWER button ON. After a short
delay, the display will read:
4. INITIALIZING PLEASE WAIT
5. Then,
6. MENU MODE? ENTER PROPER KEY
SEQUENCE
7. Press the keys in the following sequence within
10 seconds:
8. Press the ENTER button.
9. The display will read SMARTMONITOR 2 MENU
SELECTION.
10. Press the u arrow until you see “Move Data To
Card?
11. Press the ENTER button. The word NO will begin
to blink. To select YES press either arrow
button.
12. Press the ENTER button. The display will now
show Transferring Data… Once the transfer is
complete the display will change to Data
Transferred.
If the card has data on it the following is displayed
after step 11.
The display may show Card Full-Overwrite?
Press the ENTER button. The word NO will begin
to blink. To select YES press either arrow button.
Press the ENTER button. The display will now
show Transferring Data… Once the transfer is
complete the display will change to Data
Transferred.
The memory in the monitor will not be automatically cleared. The recorder data in the SmartMonitor
2 will be “Flagged” as downloaded information and, if it is not cleared before the next download, the
Synergy-E software will exclude those duplicated events. Synergy-E has the ability to retrieve all the data
if desired. Refer to the Synergy-E Manual for more information.