Reson SeaBat 7125 ROV, Operator'S Manual

Page: 149 / 200

INSTALLATION INSTRUCTIONS
SeaBat 7125 ROV Operator‟s Manual
Page 133 May 30, 2011
Version 3
B.2 Installation Checklist
NOTE
This checklist only covers the most basic, standard system installation. Depending on
the system configuration or specific customer requirements, this list may or may not
apply.
Follow these basic steps to install and configure your new SeaBat sonar system:
Install the dry-end components:
o
7125 processor
o
Monitor, keyboard, mouse
Install the wet-end components:
o
LCU
o
Receiver unit
o
Projector unit(s)
Install and connect cables:
o
Receiver to LCU cable
o
Projector to LCU cable(s)
o
LCU to 7125 processor cable
o
Auxiliary sensor cables
o
Monitor, keyboard, and mouse connections
o
Processor power cable
Power up the system
Test the system
For information on configuration of the system (including I/O module configuration,
remote operation, and folder management), see
section 4 System Configuration .
CAUTION
Before turning the system on, make sure that there is no significant difference between
the temperatures of the equipment and environment in order to prevent condensation.