RED DSMC OPERATION GUIDE: WEAPON/SCARLET-W
COPYRIGHT © 2016 RED.COM, INC
955-0116_V6.1, REV-U | 35
REMOVE THE DSMC
2
SIDEKICK
This section applies to the following items:
DSMC
2
Sidekick (Forged CF)
DSMC
2
Sidekick (Woven CF)
DSMC
2
Sidekick (Magnesium)
NOTE
: Each DSMC
2
Sidekick is compatible with any WEAPON or SCARLET-W camera.
WARNING:
Before installing or removing the DSMC
2
Sidekick, you MUST turn off the camera.
REQUIRED TOOL:
T10 TORX driver
1. Turn off the camera.
2. Use a T10 TORX driver to loosen the four (4) captive screws attaching the DSMC
2
Sidekick to the camera.
3. Remove the DSMC
2
Sidekick from the camera.
INSTALL A DSMC
2
EXPANDER
This section applies to the following items:
DSMC
2
Base Expander
DSMC
2
Base I/O V-Lock Expander
DSMC
2
REDVOLT Expander
DSMC
2
Jetpack Expander
WARNING:
Before installing or removing a DSMC
2
expander, you MUST turn off the camera.
REQUIRED TOOL:
T20 TORX driver
1. Turn off the camera.
2. Position the expander on the rear of the camera, aligning the connector on the front of the expander with
the connector on the rear of the camera.
3. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)
turns each using a T20 TORX driver. DO NOT FULLY TIGHTEN.
4. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T20 TORX driver.
WARNING:
DO NOT OVERTIGHTEN.
REMOVE A DSMC
2
EXPANDER
This section applies to the following items:
DSMC
2
Base Expander
DSMC
2
Base I/O V-Lock Expander
DSMC
2
REDVOLT Expander
DSMC
2
Jetpack Expander
WARNING:
Before installing or removing a DSMC
2
expander, you MUST turn off the camera.
REQUIRED TOOL:
T20 TORX driver
1. Turn off the camera.
2. Loosen the four (4) captive screws in a cross pattern (“X” pattern) using a T20 TORX driver.
3. Remove the expander from the camera.