RED DSMC OPERATION GUIDE: WEAPON/SCARLET-W
COPYRIGHT © 2016 RED.COM, INC
955-0116_V6.1, REV-U | 101
SERIAL PROTOCOL
NOTE
: CTRL and GIG-E ports are only available on select DSMC
2
expanders. For more information, go to
Output Connectors” on page 198
.
The camera can communicate to external devices via the CTRL and the GIG-E connectors (camera-to-camera
communication is possible only via GIG-E).
Select one of the following protocols from the
Serial Protocol
drop-down menu:
None (Default)
Element Technica
3ality SPC 7XXX
REDLINK Command Protocol
ETHERNET
NOTE
: The GIG-E port is only available on the DSMC
2
REDVOLT Expander. For more information, go to
Output Connectors” on page 198
.
Use the settings on the Ethernet tab to configure the GIG-E port. Each camera or device requires a unique IP
address. For camera-to-camera communication via Ethernet, both cameras need to be in the same sub-net
(have the same netmask address) and have the same gateway address.
Enable DHCP
: Enables DHCP. If a DHCP-server is available in the communications network, the camera
obtains an IP address, netmask address, and gateway address automatically from the DHCP server. You
cannot manually enter anything in the IP Address, Netmask, and Gateway fields when this check box is
selected.
Enable Camera to Camera
: A change to settings on this camera is sent to other cameras via the network as
a SET command (as UDP packets). The SET command then sets the property on other cameras. If this
camera receives a SET command, the camera does not send the command to other cameras/devices.
Enable External Control
: This camera can be controlled via TCP/IP from an external device.