COPYRIGHT © 2016 RED.COM, INC
RED DSMC OPERATION GUIDE: WEAPON/SCARLET-W
955-0116_V6.1, REV-U | 34
ENABLE AUTO BOOT ON POWER
1. Toggle the
Auto Boot on Power
switch to
On
(identified by a white star).
2. Connect a power source to the
DC IN
connector.
The camera turns on automatically.
3. Use one of the following methods to turn off the camera:
‒
Go to
Menu
>
Power
and select
Shutdown
.
‒
Press and hold
PWR/REC
until the
Shutting Down...
notification shows on the display.
NOTE
: Simply disconnecting the power source may result in data loss.
DISABLE AUTO BOOT ON POWER
1. Toggle the
Auto Boot on Power
switch to
Off
(identified by a black star).
The camera will not turn on automatically.
CONFIGURE YOUR CAMERA
This section describes common options for configuring your camera system.
INSTALL THE DSMC
2
SIDEKICK
This section applies to the following items:
DSMC
2
Sidekick (Forged CF)
DSMC
2
Sidekick (Woven CF)
DSMC
2
Sidekick (Magnesium)
NOTE
: Each DSMC
2
Sidekick is compatible with any WEAPON or SCARLET-W camera.
WARNING:
Before installing or removing the DSMC
2
Sidekick, you MUST turn off the camera.
REQUIRED TOOL:
T10 TORX
®
driver
1. Turn off the camera.
2. Use a T10 TORX driver to remove the four (4) screws on the BRAIN
®
side plate (if the side plate is installed).
3. Remove the BRAIN side plate (if the side plate is installed).
4. Place the DSMC
2
Sidekick in the slot where the lip of the BRAIN side plate was installed.
5. Press the DSMC
2
Sidekick down flush along the side of camera.
6. Tighten the four (4) captive screws in a cross pattern (“X” pattern) using a T10 TORX driver. DO NOT FULLY
TIGHTEN.
7. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T10 TORX driver.
WARNING:
DO NOT OVERTIGHTEN.
