CONNECT THE RED LENS CONTROL MOTOR
1. Connect a RED W.M.D. Motor Cable to the rotating connector on the RED Lens Control Motor.
2. Connect the opposite end of the RED W.M.D. Motor Cable to the corresponding lens function (Focus, Iris, Zoom)
7-pin LEMO port on the W.M.D.
3. Retract the spring-loaded thumb latch to rotate the connector to the position that you want.
4. Release the thumb latch and the rotating connector locks in place.
INSTALL A RED LENS DRIVE GEAR
1. Insert the RED Lens Drive Gear mounting rod into theRED Lens Control Motor.
2. Twist the RED Lens Gear to align the guide pins.
3. Continue to apply light pressure, the gear magnetically snaps into place when properly aligned.
Figure: RED Lens Drive Gear M 0.8 Installed
REMOVE A RED LENS DRIVE GEAR
1. Push on the RED Lens Drive Gear axle to eject the RED Lens Drive Gear from the RED Lens Control Motor.
Alternatively, grasp the RED Lens Drive Gear by the gear teeth and pull to disengage and remove the RED Lens
Drive Gear.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
4 9
RED 3-AXIS SYSTEM OPERATION GUIDE