3. After a few seconds, release the
Focus Limit
button. Iris Limit and Focus Limit LEDs flash corresponding to the
current channel setting:
Iris Limit
: Flashes to represent the tens.
Focus Limit
: Flashes to represent the ones.
For example, if the Iris LED flashes twice and the Focus LED flashes once, the current channel is 21.
4. After LEDs stop flashing, press the Iris Limit and Focus Limit buttons to set the new channel:
Iris Limit
: Press to set the tens.
Focus Limit
: Press to set the ones.
For example, to set the channel to 14, press the Iris button once, and press the Focus button four (4) times.
5. Wait a few seconds for the Iris Limit and Focus Limit LEDs to flash indicating the new channel.
NOTE:
For more information, go to
"Configure Wireless Settings" on page 28
.
WIRELESS SETTINGS
The wireless settings for the T.H.C. are managed in the W.M.D. menu. If the wireless channel is changed in the
W.M.D., the T.H.C. must be connected via a wired connection to obtain the new wireless information.
NOTE:
For an alternate method, go to
"Change the Wireless Channel" on the previous page
.
NOTE:
For more information, go to
"Configure Wireless Settings" on page 28
.
CONNECT TWO (2) T.H.C. UNITS
The W.M.D. supports up to two (2) T.H.C. units. Both units have full control over all adjustment functions. Use the lens
lock function to prevent both controllers from sending conflicting commands while both units are in operation.
Connect a second T.H.C. using the same method described in
"Pair the T.H.C." on the previous page
.
INITIALIZE WITH THE T.H.C.
In order for the W.M.D. to safely control the motors, it must be initialized to detect the range of motion for each motor.
At shutdown, the W.M.D. saves the range of motion for each motor along with the current position for 14 hours. You
can turn on/off the W.M.D. without initializing again. Initialization needs to be performed if something changes with the
the physical setup.
To initialize ALL motors:
Press and hold the
Initialize
button on the T.H.C. for two (2) seconds.
To initialize ONLY motors with errors:
Press and release the
Initialize
button.
A single motor can be initialized by disconnecting and reconnecting the motor cable.
WARNING:
Initialize the system every time a modification is made to a lens or a motor. Failing to perform the
initialization sequence may cause severe damage to your lens, motor, or camera.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
4 3
RED 3-AXIS SYSTEM OPERATION GUIDE
