FUNJINON LENS CONTROL
The W.M.D. can control Fujinon lenses through serial communication. There are two modes of control:
ENG+FIZ
: Controls focus, iris and zoom.
ENG+I
: Controls iris only.
To enable Fujinon lens control, follow the instructions below:
1. Go to
Options
>
232/422 Port
in the W.M.D. main menu.
2. Select
ENG+FIZ
or
ENG+I
.
3. Go to
Settings
>
Setup
>
Lens
in the camera menu.
4. Deselect the
Enable Power to Lens
check box.
NOTE:
The (791-0582) Fujinon Eng Lens Cable with P-tap Power is available through Element Technica.
TECHNICA PROTOCOL
You can connect a third- party system to the W.M.D. through Technica Protocol. Technica Protocol allows
configuration and control at update rates that ensure smooth motor control. Technica Protocol is available via the
following ports:
232/422 Port
: Go to Options > 232/422 Port on the W.M.D. and select Technica Protocol.
EXP Port
: Go to Options > EXP Port on the W.M.D. and select Technica Protocol.
STREAMING METADATA
You can stream metadata to an external device if the W.M.D. is not connected to a RED camera. Streaming metadata
exports data at a rate of 25 updates per second. To configure streaming metadata, follow the instructions below:
232/422 Port
: Go to Options > 232/422 Port on the W.M.D. and select Metadata Protocol.
EXP Port
: Go to Options > EXP Port on the W.M.D. and select Metadata Protocol.
SET UNITS
You can set the focus data to display in Imperial units or Metric units. To set units, go to
Options
>
Units
in the
W.M.D. menu and select
Imperial
or
Metric
.
SYSTEM POWER
Low Power mode limits the W.M.D.’s maximum power. To set Low Power mode, go to
Options
>
System Power
on
the W.M.D. and select
Normal
or
Low Power
.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
3 6
RED 3-AXIS SYSTEM OPERATION GUIDE
