INTERMITTENT WIRELESS SIGNAL
SYMPTOM
The wireless signal transmitting between the T.H.C. and W.M.D. is intermittent, resulting in intermittent or unreliable
functionality.
POTENTIAL RESOLUTIONS
The W.M.D. wireless setting (
Select
>
Wireless
>
Power
) may need to change. When the T.H.C. is close (less
than 25 feet) to the W.M.D., select
Low
. When the T.H.C. is farther away (more than 25 feet) from the W.M.D.,
select
High
.
Ensure that the RED T.H.C. and W.M.D. Antenna is securely connected to the T.H.C. and W.M.D.
Ensure that the T.H.C. is fully charged.
T.H.C. CAUSES MOTOR TO WHIPBACK
SYMPTOM
One (1) or more motors whip around when you are controlling a function on the T.H.C.
POTENTIAL RESOLUTION
Reset the T.H.C. parameters.
1. Ensure that the T.H.C. is receiving power from a charged RED Li Battery 7.2V.
2. Ensure that the T.H.C. power switch is set to
Battery
mode.
3. Remove the RED CAN Command Cable.
4. Toggle the T.H.C. power switch to
Cable
mode.
5. Adjust the Focus/Iris/Zoom controls until each control is at an end stop.
6. Press and hold the
Initialize
button on the T.H.C. for two (2) seconds. At the same time, toggle the T.H.C. power
switch to
Battery
mode.
All lights on the T.H.C. flash green five (5) times.
7. Connect the T.H.C. to the W.M.D. using the RED CAN Command Cable.
8. Toggle the T.H.C. power switch to
Cable
mode.
9. Adjust the
Limit
buttons for Focus/Iris/Zoom individually.
A. Hold down the Focus, Iris, or Zoom Limit button.
B. Move the adjustment knob until it reaches its start or end point.
C. Release the button.
D. Repeat for the Focus, Iris, and Zoom Limit buttons.
10. Remove the RED CAN Command Cable.
11. Toggle the T.H.C. power switch to
Battery
mode.
12. Press and hold the
Initialize
button on the T.H.C. for two (2) seconds.
All three (3) motors initialize automatically.
13. Test your Focus, Iris, and Zoom functions.
If you are still experiencing a problem, contact
at
.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
5 6
RED 3-AXIS SYSTEM OPERATION GUIDE
