2. Connect a RED Start/Stop cable.
A. Connect the RED Start/Stop cable to the W.M.D.
EXP
port.
B. Connect the RED Start/Stop cable to the appropriate
SYNC
and/or
CTRL
ports on the camera.
WARNING:
DO NOT connect to the SYNC connector to the CTRL port. This may cause the camera to crash.
NOTE:
For more information, go to
.
Figure: Connect RED Start/Stop Cable
3. Connect power to the W.M.D.
A. Connect a W.M.D. Power Cable to the W.M.D.
PWR
port.
B. Connect the opposite end of the W.M.D. Power Cable to a 12 V DC power supply with sufficient amperage.
NOTE:
RED recommends that you connect the W.M.D. to a dedicated power source when operating power
intensive configurations or stiff lenses that require high torque settings.
NOTE:
For more information, go to
"Wireless Motor Driver (W.M.D.)" on page 18
.
4. Connect the T.H.C.
A. Connect the 4-pin RED CAN Command Cable to the
CAN
connector port on the W.M.D.
B. Connect the opposite end of the RED CAN Command Cable to the T.H.C. (
CAN
) port.
C. Toggle the T.H.C. power switch to
Cable
mode.
NOTE:
The T.H.C. communicates wireless settings information via the RED CAN Command Cable. For more
information, go to
"Tactical Hand Controller (T.H.C.)" on page 37
.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 4 4 , R EV - H
|
1 5
RED 3-AXIS SYSTEM OPERATION GUIDE
