Series 1780 Dynamometer User Manual V1.1
Document ID: Q2D4F5
Publish date: 2020-03-06
4.2.5 Dismounting the load measurement unit from support
The load measurement using will need to be put back in the protective casing if you need to:
●
Change setup
●
Move the dynamometer to another location
●
Stop using the Series 1780 for a long time (to avoid damaging the load cell by mistake)
●
Return the unit for repair, recalibration or upgrade
In case that you need to dismount the load measurement unit, please first find the protective
casing (see section 4.2.1) from the initial package. Build it back with the metal plates and the
standoffs.
Use caution when you remove the fasteners, as the load measurement unit is sensitive and
any sudden impacts can damage the load sensor. Untighten the M5 x 40mm socket head
screws and M5 serrated flange nuts only when it is safe.
After removing the load measurement unit from the support, place it back onto the
protective case, aligning with the hex standoffs. Close the casing with the spacers and the
second metal plate, and fasten the M5 flat head screws properly to make sure that the load
measurement unit is being well protected inside.
Keep the unit inside the casing until you need it.
Copyright 2019 - Tyto Robotics Inc.
Page 36/65
