Raymarine L1250D, Owner'S Handbook Manual

Page: 43 / 246

Chapter 2: Installation 2-11
Cab
le
Run
s
• Sounder Power cable , supplied with the DSM250. This 10 ft (3 m) cable
has a connector plug at one end for connecting to the sounder module, and
3 wires at the other end for connecting the power supply.
• HSB cable , supplied with the unit. This 10 ft (3m) cable is used to connect
the DSM250 to the display unit. Other lengths of HSB cables are available
from Raymarine. See
Table 2-1 Parts and Accessories on page 2-4.
• SeaTalk cable , optional, with SeaTalk connector(s) at one or both ends.
• NMEA Output cable , optional, with an NMEA OUT connector at one
end only.
• Transducer cable , supplied with the transducer. This 30 ft (10 m) cable
has a connector plug (with an outer nut that you must attach) at one end for
the sounder module or extension cable. The transducer cable may be
extended up to a maximum of 60 ft (20 m) using optional extension cables.
For details, see document number 81196,
Transducers for Fishfinders
Owner’s Handbook.
Note: The transducer cable connector has a nut that has been removed to aid
installation. There is no need to cut the transducer cable for installation.
WARNING:
Do not cut the transducer cable or remove the connector.
Do not try to shorten or splice the cable.
Cutting the transducer cable will severely reduce sonar performance.
If the cable is cut, it must be replaced—it cannot be repaired.
CUTTING THE CABLE WILL ALSO VOID THE WARRANTY.
81213_1.book Page 11 Monday, March 17, 2003 1:14 PM