Raven Envizio Pro, Installation & Operation Manual

Page: 72 / 232

Chapter 6
62 Envizio Pro and Envizio Pro II Installation and Operation Manual
AccuBoom™ Setup
If the optional AccuBoom system has been installed, touch the AccuBoom button to enable the AccuBoom
feature and select a spray zone map.
Note:
Refer to Chapter 9, Using AccuBoom™, for more information about using AccuBoom.
The Status for the optional AccuBoom node may be displayed as follows:
•
Disabled - Node is connected and communicating but optional features are not enabled for this
system.
•
Enabled - Node is connected and communicating and optional system features are enabled.
•
Node Offline - The node is currently not detected by the field computer.
If selected, the name of the selected spray zone map will be displayed in the zones field.
Product Setup
To setup product nodes or control channels, select the corresponding Product button to setup the product
control for the selected node.
Note:
If the status of any nodes connected to the CANbus display ‘Node Offline,’ refer to Chapter 4, CAN
Networking and Diagnostics, before starting the job.
If the optional multiproduct activation key is entered, up to four product nodes or control channels
will be displayed on the Verify Settings screen.