![Raven Envizio Pro Installation & Operation Manual Download Page 112](http://html2.mh-extra.com/html/raven/envizio-pro/envizio-pro_installation-and-operation-manual_3837084112.webp)
Chapter 7
102
Envizio Pro and Envizio Pro II Installation and Operation Manual
Valve Advance (Standard, Fast or Fast Close Valve)
This feature allows the operator to set the amount of time (in seconds) which the control valve will remain open
after boom sections are toggled off while in automatic rate control mode. A value of 1-9 means an advance of
1-9 seconds respectively. A value of 0 means no advance. This setting may be used in conjunction with the
valve delay for low rate applications to build up pressure when the master switch is toggled on. For best
results, approach the headlands at consistent speeds while turning boom sections off.
Note:
The Advance button is only displayed if a Standard, Fast or Fast Close valve is selected and if the
assigned product control node has software version 1.50 or higher.
Reset Valve Cal
Touch the Reset Valve Cal button to replace the current valve cal with the recommended value from the table
shown above.
Modify PWM Settings (PWM or PWM Close Valve)
If either ‘PWM’ or ‘PWM Close’ is selected as the valve type, a Modify PWM Settings button will display.
Select one of the following methods to configure the PWM control valve associated with the selected node or
control channel.
Manual Calibration.
The manual calibration mode allows the operator to manually enter the PWM minimum,
maximum and preset values to known values using an on-screen keypad.
Note:
The PWM valve is not operated in the manual calibration mode. It is recommended to verify that
any changes to these settings have the desired affect before controlling product application.
Refer to the PWM Calibration Screen section on page 104 for more information on the PWM
values configured using the manual calibration mode.
Summary of Contents for Envizio Pro
