Raven Envizio Pro, Installation & Operation Manual

Page: 70 / 232

Chapter 6
60 Envizio Pro and Envizio Pro II Installation and Operation Manual
The Select Job screen will be displayed.
To Resume an Existing Job: Select the existing job file from the list and touch the Accept icon to return to the
Verify Settings screen.
When the Guidance screen is displayed, coverage maps from the existing job will be displayed on the
Guidance screen.
To Start a New Job: On the Select Job screen, touch the Create New icon. The New Job: Enter
Name screen is displayed.
Use the on-screen keypad to enter the name of the new job file. Touch the Accept icon to
confirm the entered name and return to the Start Job - Verify Settings screen. Touch the Cancel
icon to return to the Start Job - Verify Settings screen without accepting the job name.
Note:
Job names stored on the field computer cannot begin or end with a space.
Guidance Pattern Setup
Touch the Pattern button to select the guidance pattern best suited to the field and type of application.
The following icons represent the available guidance patterns.
The following descriptions may be helpful when selecting the type of guidance pattern for use during the
actual field application. See the
Using Guidance Patterns section on page 65 for more information on using
guidance paths during the job.
Enhanced Last Pass. The Last Pass pattern uses the last, or nearest, applied or covered area and the
guidance width to display the next guidance path. While this pattern does not require the operator to set ‘A’
or ‘B’ points, a previously applied or covered area is required in the active job to use this pattern.
The Last Pass guidance pattern has been enhanced to provide accurate steering along the displayed
guidance path with systems such as the Raven SmarTrax or SmartSteer assisted steering systems. Contact
a local Raven dealer for more information about these Raven assisted steering systems.
Enhanced
Last Pass
Straight (A-B) Line
Pivot
Fixed Contour