Rancilio MD80, Use And Maintenance

Page: 37 / 64

37
4. USE
The machines have been disegned and manufactu-
red to grind coffee beans for professional use.
Any other use is to be considered unsuitable and
therefore dangerous.
In case of domestic use, the installer or the
seller are responsible for the user’s training.
The manufacturer cannot be held re-
sponsible for any damage caused by
unsuitable, erroneous or irrational use of
the machine.
The user must always follow the indications contai-
ned in this manual. In the case of a failure or if the
machine is not working properly, switch it off and do
not attempt any direct repair.
Contact the assistance service.
The user must not:
●
put his hands under the ground coffee container;
●
touch the machine with wet or damp hands or
feet;
●
transport the machine or carry out maintenance
operations with the plug connected and when the
machine is warm;
●
pull the supply cable in order to disconnect the
machine from the supply network;
●
use the machine if the supply cable is damaged;
●
dip the machine in water or other liquid;
●
wash the machine with water or vapour jet;
●
use the machine when there are children in its
proximity;
●
allow the machine to be used by children or inca-
pable person;
●
obstruct the suction or heat despersal grilles with
cloths, ect.;
●
leave the side doors open;
●
place container with liquid on the machine
It is forbidden to install or use the machine if
it is be wet or damp.
It is always necessary to request an accu-
rate check by qualified personnel in order
to find any possible damages to the electric
components.
4.1. Counter-instructions
This machine may be used only for the purposes
for which it was designed. It cannot be used to di-
spense products other than coffee or any non food
products.
The manufacturer cannot be held re-
sponsible for any damage caused by
unsuitable, erroneous or irrational use of
the machine.
5. TRANSPORT
The machine must always be transported in a correct
position following the instructions on the cardboard
box.
Do not turn over the machine or lay it down
on a side.
The box also contains separate accessories and a
technical documentation which must be saved for
further consultations.
●
Check on delivery that the machine and the ac-
cessories supplied correspond to those described
on the delivery note.
●
Open the top part of the packaging, remove the
accessories and then remove the machine from
its packaging.
●
Check if the machine, the accessories, the electric
cable and the plug are in perfect condition. Should
one of these parts be damaged, immediately con-
tact the retailer.
The packing elements (plastic bags,
expanded polystyrene, nails, cardboard,
etc.) must not be left within reach of
children as they are potential sources of
danger.
Do not dispose of the packing elements
in the environment; consign them to firms
authorized for their disposal,
6. INSTALLATION
Operations to be effected by professio-
nally qualified personnel.
The machine is delivered ready to be installed in
accordance to the label data Fig.1.
Ensure that the electrical supply system has the same
features as the machine.
The electrical supply system must be equip-
ped with a life saving device or a general
automatic switch with an efficient earthing
system. Should there be no electrical pro-
tection element, have a single-pole switch
installed by qualified personnel, as envisa-
ged by the current safety regulations with a
contact opening distance of either equivalent
or over 3 mm.
The earthing of the appliance is compul-
sory.
The constructor declines all responsibility
in the event of the failure to respect the
accident prevention norms.
Take care not to damage the supply cable by
pressing, or crushing.