art. 1518
WARNING:
* always read the instruction before using power tools
* always wear safety googles
* wear hearing protection
OPERATING INSTRUCTION
1. Warning
1.1 Air pressure
The air pressure must be restricted at or less than maximum presure 90
psi (6.2 bar), do not exceed it.
1.2 Air line
Use an air hose between the compressor and the tool. The
corresponding hose internal diameter is recommended in the attached
table in the data sheet. Compressed air is cooled and its water content
separated as soon as the air leaves the compressor. However some of
the water is condensed in the piping, and can enter the tool mechanism
and cause damage. An air filter and on oiler should be installed between
the compressor and the tool. Use a recommended compressor in the
date sheet or larger for each tool.
1.3 Air hose
Clean the hose with a blast of compressed air before connecting the
hose to air tool. This will prevent both moisture and dust within the
hose from entering the tool an causing possible rust or malfunction. To
compensate for unusually long hose (over 25ft) the line pressure should
be increased accordingly.
1.4 Approved eye protection, mask, hearing protection and gloves shall
be worn when operate this tools.
1.5 The working place shall be ventilated.
1.6 Release the on-off device in case of air supply failure.
1.8 Use only a lubricant recommended by the manufacturer.
1/4" Pneumatic angle grinder
Art.
Code
Free speed
Max. Air pressure
Air consumption
Air inlet
Lenght
Weight
1518
617730
11000 RPM
6,2 bar
170 l/min
1/4"
230 mm
1920 g
1.7 Release the start and stop switch in case of a failure of energy
supply.
Summary of Contents for 1518
Page 4: ......
