Radyne MM200, Installation And Operation Manual

Page: 106 / 192

Appendix A MM200 High-Speed Microwave Modem
A-6 TM086 – Rev. 4.1
<2> Demod Summary
Fault Bit 0 = Demodulator Fault
Bit 1 = Demodulator channel 1 fault
Bit 2 = Demodulator channel 2 fault
Bit 3 = Demodulator channel 3 fault
Bit 4 = Demodulator channel 4 fault
Bit 5 = Demodulator interface 1 fault
Bit 6 = Demodulator interface 2 fault
Bit 7 = Demodulator interface 3 fault
Bit 8 = Demodulator interface 4 fault
Bits 9 – 15 = Spares
Opcode: <0x203E> Query common configuration
Query Response
<1>
<1>
<1>
<1>
<1>
<1>
<1>
<1>
Control Mode
Last Rate Control
User Mode
Frequency Plan
Common Alarm 1
Mask
Common Alarm 2
Mask
Mux Loopback
Repeater Mode 0 = Local, 1 = Terminal, 2 = Remote, 3 = Ethernet
0 = Symbol, 1 = Data, 2 = Auto
0 = Reserved, 1 = All Access, 2 = Level 1, 3 = Level 2
0 = Auto, 1 = User
0 = Mask, 1 = Allow
Bit 0 = Glue Logic CPLD Fail
Bit 1 = M&C Test FPGA Fail
Bits 2 – 7 = Spares
0 = Mask, 1 = Allow
Bits 0 – 7 = Spares
0 = Normal, 1 = Mux/Dmx Loop, 2 = Mux/Dmx LVDS,
3 = Modem LVDS, 4 = Repeater
0 = Off, 1 = On
Opcode: <0x2054>
Query the carrier enable status
Query Response
<1> Carrier Status 0 = Off, 1 = On
Opcode: <0x2055>
Query the carrier mode
Query Response
<1> Carrier Mode 0 = Normal
1 = CW
2 = Offset 1 Hz
3 = 100 kHz
4 = 3.5 MHz
5 = Sweep Up
6 = Sweep Down
Opcode: <0x2070> Query a selected modulator’s channel status
Command Data Field 1 Byte
<1> Selected channel
number 0 = channel1
1 = channel2
2 = channel3
3 = channel4