Radyne MM200, Installation And Operation Manual

Page: 53 / 192

MM200 High-Speed Microwave Modem User Interfaces
TM086 - Rev. 4.1 4-29
ALL ALARMS {No, Yes}
Used for dispersive fading analyzer
testing.
RW RW RW
DATE {YY/MM/DD}
Allows the user to enter the current date.
RW RW RW
TIME {HH:MM:SS}
Allows the user to enter the current time.
RW RW RW
FRONT PANEL (menu)
LEVEL
TIMEOUT
KEY CLICK
{Low, Mid, High, Off}
Set the front panel backlight intensity
level.
{0 – 99}
Allows the user to enter the amount of
time in seconds for the backlight to dim.
Enter ‘0’ for no timeout.
{On, Off}
Allows the user to choose between silent
and audible button depression.
RW
RW
RW
RW
RW
RW
RW
RW
RW
REMOTE PORT (menu)
REMOTE ADDR
REMOTE BAUD
REMOTE LINE
Sets the multidrop address of the remote
port.
Sets the baud rate of the remote port.
{RS485, RS232}
Sets line control for remote port.
RW
RW
RW
RW
RW
RW
RW
RW
RW
TERMINAL (menu)
TERM BAUD
EMULATION
Sets the baud rate of the terminal port.
{VT 100, WYSE 50, ADDS VP}
Allows the system to emulate an ASCII
dumb terminal.
RW
RW
RW
RW
RW
RW
HW/FW CONFIG (menu)
LOAD DEFAULT (menu)
PASSWORD
DEBUG MODE (menu)
DBG PASSWORD
SNMP DEFAULT (menu)
SNMP PASSWORD
Allows the user to set the system
configuration to default settings. This
selection is password protected.
Password field for enabling the default
system configuration overwrite.
Allows the user to enable the Debug Mode
(this selection is password protected).
Password field for enabling the debug
mode (factory use only).
Allows the user to set the SNMP Controls
to the default settings.
Password field to set the SNMP defaults.
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW