Radyne MM200, Installation And Operation Manual

Page: 64 / 192

User Interfaces MM200 High-Speed Microwave Modem
4-40 TM086 - Rev. 4.1
Figure 1. Object Identifiers in the Management Information Base (Sheet 2 of 2)
Refer to Appendix B for MIB listing.
4.12 Terminal Port User Interface
The Terminal Port of the MM200 allows for complete control and monitoring of all MM200
parameters and functions via an RS-232 Serial Interface. Terminal Mode’ can be entered from
the front panel by selecting ‘System’ and then ‘Control Mode’ followed by ‘Terminal.’ The default
settings for the terminal are as follows:
19,200 Baud; 8 Data bits; 1 stop bit; No parity
The baud rate can be changed at the front panel by using the
System>Baud Rate Menu.
The new baud rate does not take effect until power to the unit has been shut down and turned
back on again.
The Terminal Control Mode is menu-driven and the allowable values for each item number will be
shown. To change an item, type in its number followed by <ENTER>. If the parameter to be
changed requires a numeric value, enter the number followed by <ENTER> If the parameter is
non-numeric, press <SPACE> to cycle through the list of available entries. Note that the items
that do not have ID numbers are Status only and cannot be changed.
4.13 Modem Configuration
4.14 Connecting the Terminal
1.
Connect the computer to the MM200 Terminal Connector (J2) on the rear of the unit using
the RS-232 Cable (Figure 1).