Radyne MM200, Installation And Operation Manual

Page: 103 / 192

MM200 High-Speed Microwave Modem Appendix A
TM086 – Rev. 4.1 A-3
Command Repeater Mode 0x220D Selects the repeater mode
Command Mod Frequency 0x2240 Set modulator frequency
Command Mod Data Rate 0x2241 Set modulator data rate
Command Mod Symbol Rate 0x2242 Set modulator symbol rate
Command Mod Modulation 0x2244 Set modulator modulation
Command Mod Spectrum 0x2245 Set modulator spectrum
Command Mod Alarm Mask 0x224E Set modulator alarm masks
Command Mod PRBS 0x224F Set modulator PRBS
Command Mod Tx Power 0x2253 Set modulator power
Command Mod Carrier Control 0x2254 Set modulator control disable/enable
Command Mod Carrier Mode 0x2255 Set modulator carrier mode
Command Mod IF Separation 0x2258 Set modulator IF separation
Command Mod Channel Setting 0x2259 Set modulator channel setting
Command Mod User Frequencies 0x225A Set modulator user frequencies
Command Mod Bandwidth 0x225B Set modulator bandwidth
Command Mod Channel Config 0x2270 Set selected modulator channel configuration
Command Tx Interface Config 0x2271 Set selected Tx interface configuration
Command Tx Interface Jitter Control 0x2272 Set selected Tx interface jitter control
Command Demod Frequency 0x2280 Set demodulator frequency
Command Demod Data Rate 0x2281 Set demodulator data rate
Command Demod Symbol Rate 0x2282 Set demodulator symbol rate
Command Demod Demodulation 0x2284 Set demodulator demodulation
Command Demod Spectrum 0x2285 Set demodulator spectrum
Command Demod Alarm Mask 0x228E Set demodulator alarm masks
Command Demod IF Separation 0x2298 Set demodulator IF separation
Command Demod Channel Setting 0x2299 Set demodulator channel setting
Command Demod User Frequencies 0x229A Set demodulator user frequencies
Command Demod Bandwidth 0x229B Set demodulator bandwidth
Command Demod Acquisition 0x229C Set demodulator acquisition parameters
Command Demod Diversity Mode 0x229D Command demodulator diversity mode
Command Demod Clear BER 0x229E Clear demodulator BER
Command Demod Channel Config 0x22B0 Set selected demodulator channel
configuration
Command Rx Interface Config 0x22B1 Set selected Rx interface configuration
Command Rx Interface Jitter Control 0x22B2 Set selected Rx interface jitter control
Command Rx Interface Byte Gapping 0x22B3 Set Selected Rx interface byte gap