Radiolink Electronic Ltd
61
• Channels controlled: Twin ailerons, flap and spoiler may be set independently in BUTTERFLY,
including set to
0 to have no effect.
• Twin aileron servos: If AIL-DIFF function is inhibited, then AIL1 and AIL2 settings will have no
effect. If AIL-DIFF is active, then CH1 and CH7 may be independently adjusted.
• Normally both ailerons are raised equally in BUTTERFLY, and the elevator motion is set to
maintain trim when the ailerons rise. Different amounts may be set for each aileron to correct for
torque reactions and other unique characteristics of the model.
Be sure you understand what dropping ailerons will do when in BUTTERFLY. Along with creating an
enormous amount of drag (desirable for spot landings), this also creates "wash-in", a higher angle
of attack where the ailerons are, and encourages tip stalling. If you are using this for aerobatic
performance and not "sudden stops", consider raising the ailerons and dropping the flaps in stead
as shown in the diagram above.
Goals
Steps
Inputs
Activate BUTTERFLY.
Adjust the aileron and
flap travel to 75%
Elevator
setting
is
adjustable
in
the
B.FLY-ELE.
MIX switch is selectable
Open the BUTTERFLY
function
to BASIC .
again to ADVANCE
to BUTTERFLY,
Activate the function
SWA to UP position
to MIX
,
to OFF
Adjust the travels as
needed.
(Ex: Aileron each 75%, Flap
75%)
to AIL1
,
to 75%
,
to FLP
,
to75%
,
to AIL2
,
to 75%
,
Close
4.3.9 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the rudders with aileron operation or the
ailerons with rudder operation.
Aileron-to-rudder mix (AILE RUDD): automatically creates a "coordinated turn".
Rudder -to-aileron mix (RUDD AILE): used to counteract undesirable roll (roll coupling) that
happens with rudder input, especially in knife-edge.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from
aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate
the mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE RUDD setting for each flight condition can be set.