Radiolink Electronic Ltd
28
【
F/S
】
1
：
AILE NOR
CH1
：
AILE
2
：
ELEV NOR
NOR
F/S
3
：
THRO 15%
4
：
RUDD NOR
CH9:
NOR
5
：
GEAR NOR
CH10:
NOR
6
：
FLAP NOR
CH11:
NOR
7
：
AUX1 NOR
CH12:
NOR
8
：
AUX2 NOR
Adjustability:
•Each channel may be set independently.
• The NOR (normal) setting holds the servo in its last commanded position.
• The F/S (Failsafe) function moves each servo to a predetermined position.
• NOTE: the setting of the throttle's F/S also applies to the Battery F/S.
• The F/S is used in certain competitions to spin the MULTIROTOR to the ground prior to flying
away and doing potential damage elsewhere. Conversely, may also be used to go to neutral on all
servos, hopefully keeping the plane flying as long as possible.
• Competition modelers often maintain the NOR function so that brief interference will not affect
their model's maneuver.
• Set the throttle channel so that the engine idles when there is interference (ACRO). This may
give enough time to fly away from and recover from the radio interference and minimize damage if
crashed.
• For helicopters, NOR is typically the safest choice.
•We also recommend setting a gasoline engine's electronic kill switch to the OFF position in the
F/S function for safety reasons.
If you specify a F/S setting, the Failsafe data is automatically transmitted once each two minutes.
(PCM) When you choose the F/S mode, check that your settings are as desired by turning off the
transmitter power switch and verifying that the servos move to the settings that you chose. Be sure
to wait at least two minutes after changing the setting and turning on the receiver power before
turning off the transmitter to confirm your changes have been transmitted.
Goals
Steps
Inputs
Change the receiver
Failsafe command for
channel 8(gasoline engine
kill switch) to a preset
position. NOTE: This is
one of several functions for
which the radio requires
confirmation to make a
change.
Open BASIC menu, then
Open F/S.
for 1s .(If ADVANCE
again) .
to F/S, PUSH
Choose channel to
change(Ex:CH.8)
to CH8 ,PUSH
Set and confirm fail safe
command.
that controls CH8 to desired OFF position.
to adjust ,PUSH
Repeat as desired
Close
2.3.11 Auxiliary Channel Function (including channel 9-12 controls)
(AUX-CH): defines the relationship between the transmitter controls and the receiver output for
channels 5-12. Also, the CH9-12 POSI are used to change the CH9-12 servo direction.
Note that the CH9-12 functions are only visible in the AUX-CH screen and modulation mode must
be PCM or 2.4G.
