501510 Rev. S
Troubleshooting
6-9
6.4.7
No Source Drive
A move was initiated from a Tape Drive that is not installed.
6.4.8
Tape Not Ejected
A move was initiated from a Tape Drive that has not yet ejected its cartridge.
6.4.9
The Door is Locked
A command was given to open the Front Panel/Door but it is physically locked.
6.4.10
The Door is Open
A command was issued but cannot be completed because the Front Panel/Door is
open.
6.5
Calibration Fault Messages
These occur during calibration, which should only be done after certain upgrades and
servicing. In addition to these, any of the POST (Power On Self Test) faults can hap-
pen during calibration.
6.5.1
Calibration Fault
A motion fault happened during calibration. Make sure the motors turn freely and the
library is set up properly for calibration.
6.5.2
Failed No Magazine
Calibration has failed because no magazine was installed in position MA.
6.5.3
Failed, Remove Cart
Calibration has failed because there is a cartridge in MA. Calibration requires that
the first magazine be installed and empty.
6.5.4
Failed Gripper Full
Calibration has failed because there is a cartridge in the Handler. Calibration re-
quires that there be no cartridge in the Handler.
Summary of Contents for RLS-4470
