5-8
The Private Menu
501510 Rev. S
12.
Press the ENTER key to start editing the
Access
value (entering a password).
A flashing cursor should appear at the first character's position.
•••••••••••••Private
Access: ??????????
•
Adapter
•
Cabling
•Calibration
CALIBRATE
CLEAR ACCESS
•
Configuration
•
Control Panel
•
Display A/D
•
Display Locations
•
Display Positions
•
Drivebay
•Executive
•I2c
•Magazine
OPEN VIOP WINDOW
REBOOT
RESET SCSI BUS
•Sensor
NOTE
If a MASTER SECURITY message appears, instead of a flashing cursor in step 11 above,
follow the instructions in Section 5.2.3 to disable the Master Security Lock, then repeat
this section to set the desired password.
13.
Press the (UP) or (DOWN) key repeatedly to select the desired character (be
sure to use the correct capital and lower-case letters), then press the ENTER key
once to shift the flashing cursor to the next character position.
14.
Repeat step 12 to finish entering the password.
15.
Press the MENU key repeatedly to leave the menu system and set the password.
Summary of Contents for RLS-4470
