Enterprise Multi-WAN VPN QoS Router
50
through WAN1?
As in the figure below, select “HTTP[TCP/80~80]” from the pull-down option list
“Service”, and then in the boxes of “Source IP” input “192.168.1.0 ~ 0” (which means to
include all Intranet IP addresses). Retain the original numbers “0.0.0.0” in the boxes of
“Destination IP” (Which means to include all Internet IP addresses). Select WAN2 from the
pull-down option list “Interface”, and then click “Enable”. Finally, click “Add New” and the
rule will be added to the mode. After the rule is set up, only packets that go to Port 80 will
be transmitted through WAN2, while other traffics will be transmitted through WAN1.
Example 2
：
How do I configure Protocol Binding to keep traffic from all Intranet IP addresses
from going through WAN2 when the destinations are IP 211.1.1.1 ~ 211.254.254.254 as well
as the whole Class A group of 60.1.1.1 ~ 60.254.254.254, while traffic to other destinations
goes through WAN1?
As in the following figure, there are two rules to be configured. The first rule: Select “All
