QMS 1725E, Reference

Page: 90 / 288

Printer Engine Features
QMS 1725E Print System Reference 4-54
Printer Engine Features
Through the Administration/Engine menu you can set print engine-
related parameters.
Adjusting the Image Alignment
This option allows you to adjust the horizontal and vertical placement
of printed images.
To check image alignment, print a standard status page (Administra-
tion/Special Pages/Print Status). When the printer is placing images
properly, the alignment angle bar in the lower-left corner of the status
page is 0.5"/12.7 mm from the left and bottom edges of the page. If
the angle bar is off, use the Administration/Engine/Image Alignment
option to align the image horizontally and vertically in pixel incre-
ments (1/300" or 0.08 mm).
» Note: Engine constraints may limit the accuracy of pixel alignment.
Notes If disk swapping is enabled and the hard disk is removed or not
turned on, the printer does not automatically reset to the
factory defaults. It assumes there was an error and allows for
recovery, such as turning on the external hard disk before
turning on the printer.
The printer must be restarted for changes to the Enable Disk
Swap menu to take effect. You can either let the printer restart
automatically after you save the change and exit from the
Configuration menu, or you can wait for the change to take
effect the next time you manually turn on the printer.