QMS 1725E, Reference

Page: 122 / 288

End Job Mode
QMS 1725E Print System Reference 5-22
your print queuing system documentation, your network administra-
tor, or your QMS vendor for more information.
Setting the End Job Mode via the Control
Panel
Use the following procedure to set the end job mode from the printer’s
control panel for printers connected via the serial or parallel interface
to a stand-alone PC, a PC print server, or some other type of print
queuing system:
» Note: If you print both serial and parallel protocol jobs, then you must set
the end job mode for each protocol.
Wait for the printer to go idle, and then press the control panel keys in
the order shown in the following instructions to access the End Job
Mode option. The printer responds by displaying a status message in
the message window.
» Note: You may need to press the Next key one or more times to advance
through the list of selections or options.
Key Purpose Message Window
Online/
Offline Turns off the Online/Offline indicator and
readies the printer for configuration.
IDLE
Menu Accesses the configuration menu.
CONFIGURATION
OPERATOR CONTROL
Next Advances to the Operator Control/
Administration menu.
CONFIGURATION
ADMINISTRATION
Select Accesses the Administration menu
ADMINISTRATION
COMMUNICATIONS
Next Advances to the Communications/Parallel
(or Serial) menu.
COMMUNICATIONS
PARALLEL ( or
SERIAL)
Select Accesses the Parallel (or Serial) menu.
PARALLEL/SERIAL
MODE
Next Advances to the Parallel (or Serial)/End
Job Mode menu.
PARALLEL/SERIAL
END JOB MODE
Select Accesses the End Job Mode menu.
END JOB MODE
OPTION