QMS 1725E, Reference

Page: 153 / 288

Intellifont SIMM
6-23 Printer Options
Removing a SIMM
If both of the SIMM connectors are filled and you want to install more
memory (for example, if you want to replace an 8 MB SIMM with a 32
MB SIMM), use the following procedure to remove a SIMM. Then
refer to the previous section, “Installing a SIMM,” for installation
instructions.
» Note: SIMM connector 0 (DRAM 0) must always have a SIMM installed.
1 If you have not already done so, access the tray assembly by
following the instructions in “Removing the Tray Assembly,”
earlier in this chapter.
2 Using the release latch located on each side of the SIMM
connector, release the SIMM.
3 Gently tilt the SIMM forward to a 45° angle. Then slide the
SIMM up and out of the SIMM connector.
4 And then... go to ther previous section, “Installing a SIMM.”
Intellifont SIMM
An optional Intellifont SIMM increases the number of fonts available
to the HP PCL 5 emulation on your printer from 20 to the 37 PCL 5
fonts available on a Hewlett-Packard LaserJet 4Si.
Notch