QMS 1725E, Reference

Page: 184 / 288

Emulations on the
Hard Disk
QMS 1725E Print System Reference 6-54
will describe the procedure for copying and removing emulations
on the hard disk.
Installing an Optional Emulation
O Caution: You must have a minimum of 12 MB of RAM to run an emulation
that has been copied to a hard disk.
Use the Install Option selection from the Disk Operations menu.
Refer to the instructions in chapter 4, “Printer Configuration,” for using
the printer control panel. To install an optional emulation, use this pro-
cedure:
1 Make sure the printer is on and idle. From the Administration
menu, select the Disk Operations submenu.
2 Press the Next key until
INSTALL OPTION
displays.
3 Press the Select key.
Then press the Next key until the destination of the optional emu-
lation displays in the message window.
4 Press the Select key.
Then press the Next key until the source of the optional emulation
displays in the message window.
5 Press the Select key.
You are prompted to insert the emulation card into the card slot.
6 The hard disk then copies the contents of the card. When all
of the contents are copied, press the Menu key to exit the
menu. Press the Online/Offline key to allow the printer to
receive data from the host.
Removing a Printer Emulation
Use the Remove Option menu selection if you need to remove an
installed option from the hard drive. To remove an emulation, you
need the original emulation card containing the emulation files. The