QMS 1725E, Reference

Page: 180 / 288

Fonts on the Hard
Disk
QMS 1725E Print System Reference 6-50
Fonts on the Hard Disk
Optional fonts can be installed in two ways:
n You may use optional fonts by inserting the font card in one of the
card slots below the printer's paper cassette. However, when you
remove the font card from the card slot, you can no longer use
those fonts. This procedure is covered in the “Using a Font Card”
section found earlier in this chapter.
n You can copy the contents of a font card to a hard disk if one is
available. The procedure that follows describes how to install the
font card on your hard disk. Once the font is stored on disk, they
can be downloaded to the printer's memory when needed for
printing.
Installing an Optional Font
Procedure
After you have accessed the Administration/Disk Operations menu,
press the control panel keys in the order shown in the following table.
The printer responds by displaying a status message in the message
window (DSK refers to the hard disk number, and CAR0 and CAR1
refer to the font card slot number).
» Note: You may need to press the Next key one or more times to advance
through the list of selections or options.
Key Purpose Message
Select Accesses the Administration/Disk
Operations/Install Option menu.
DISK OPERATIONS
INSTALL OPTION
Select Accesses the Format Disk/Dsk#: menu.
INSTALL OPTION
DSK#: x
Next Scrolls through the list of attached
disks.
FORMAT DISK
DSK: x
Select Selects the disk and accesses the card
address from which the optional font is
being installed.
INSTALL SOURCE
CAR#: x