QMS 1725E, Reference

Page: 190 / 288

Kanji Fonts
QMS 1725E Print System Reference 6-60
2 Change the following Kanji settings on your printer.
Press the Previous or Next key to advance through the differ-
ent memory client
Memory Client
Minimum Kanji Setting
K Mem for Spool 112
K Mem for PSHeap 3540
K Mem PS Fonts 1024
K Mem Emulation 768
K Mem Emul Temp 256
K Mem Display 202
K Mem Disk Cache 256
Match a control panel memory client that needs to be changed
with an associated minimum Kanji setting above. With that mem-
ory client displayed in the message window, press the Select key
once.
» Note: If you are unable to reassign the memory in the memory clients to
satisfy the minimum required settings shown in the preceding table, you
will need to add more memory to your printer. See the “Memory” section
found in this chapter for SIMM installation instructions.
3 A numerical value is displayed (expressed as a 5-digit num-
ber), showing the current memory setting for that specific
memory selection. Using the Previous or Next key, change
the value of each digit (up or down) to reflect the new mem-
ory setting shown in step 2.
4 Repeat steps 2 and 3 for each memory setting that needs to
be changed. If you set the wrong value for a memory client,
repeat the procedure only for that memory client.
5 When you have changed all of the specified memory clients
to their new settings, press the Menu key until the Online or
Ready indicator lights.
This causes the printer to reset and it may take a few minutes
before it returns to
IDLE
.