Maintenance
5-13
5.3.1 Replacing the Fuser Unit
Note:
Don´t touch the top of the Fuser Unit,
it might be very hot.
S
Press first
.
OFFLINE
will be displayed.
S
Open the front (21) cover.
S
Press lever (9C) down and pull the Fuser Unit (9) on the grip (9D) about
b
out of the housing. Grasp the grip (9B) with the other hand and pull it toward
you off the printer housing.
S
Insert a new Fuser Unit (9) and push it into the printer until you hear a
click
.
S
Close the front (21) cover.
Note:
Take away the safety foil (3) before inserting the Fuser Unit (see page
before)!
Note:
Change to the
OFFLINE
mode and reset the
FUSER INFO
(see
BASIC SETTINGS
º
º
º
º
CONFIG MENU
)
Maintenance
5-14
5.4 Replacement of the PC Cartridge (OPC)
If the print quality gets worse the PC Cartridge (8) should be replaced.
It is only allowed to use a PC Cartridge that has been released for the printer.
Note:
S
The PC Cartridge is very light-sensitive, so it is wrapped up in
lightproof foil. Carefully remove the drum from its foil container.
S
Please do not touch the green part of the PC Cartridge with your
fingers. Oil and dirt degrade print quality.
S
Do not expose the light-sensitive PC Cartridge to room lighting or
sunlight any longer than necessary.
S
Press first
.
OFFLINE
will be displayed.
S
Open the front (21) cover.
S
Press the lever (26) to the top to slide the Developer Unit away from the PC
Cartridge.
S
Remove the connector (8A).
S
Press lever (8B) down and pull the PC Cartridge (8) about
b
out of the
housing and grasp the grip (8C) with the other hand and pull it toward you
off the printer housing.
S
Insert a new PC Cartridge by using the upper and lower iron band guides
and push it into the printer until you hear a
click
.
S
Mount the connector (8A).
S
Fix the new PC Cartridge by pressing down the lever (26).
S
Close the front (21) cover.
Note:
Change to the
OFFLINE
mode and reset the
OPC INFO
(see
BASIC SETTINGS
º
º
º
º
CONFIG MENU