PSI PP 4050, User Manual, Page: 51 / 120

5-1
5 Maintenance
How to use this Section
Chapter 5.1 up to 5.4 inform how to install the consumables. The user
preventive maintenance is described in chapter 5.5
Note:
For information about the lifetimes of the consumables see Chapter 7
Technical Data .
After replacing the consumables document the installation on the pages
in
Chapter 9 Maintenance / Logbook .
5.1 Installing the Parts of the Toner Kit
A Toner Kit comprises:
Standard Toner MICR Toner (PP4050 only)
10 Toner Cartridges (1) 10 Toner Cartridges MICR (1)
5 Waste Toner Bottles (2); change it
with every second Toner Cartridge 5 Waste Toner Bottles (2); change it
with every second Toner Cartridge
1 Fuser Cleaner Platen (3) 1 Fuser Cleaner Platen (3)
5 Cleaner Felts (4); change it with
every second Toner Cartridge 10 Cleaner Felts (4); change it with
every Toner Cartridge
5 Ozone Filters (5), change it with
every second Toner Cartridge 5 Ozone Filters (5), change it with
every second Toner Cartridge
Maintenance
5-2
5.1.1 Refilling the Toner
By the message
14 TONER EMPTY
in the display the printer indicates that the
toner cartridge has to be replaced by a new one.
Note:
The message 16 TONER LOW is only a warning that the printer will run
out of toner soon; but don´t replace the toner cartridge!
Only toner that has been released for the printer must be used. This toner is
part of the before mentioned Toner Kit.
Note:
Take care not to spill any toner inside the printer.
S
Press first . OFFLINE will be displayed.
S
Open the front cover (21) including the Control Panel.
S
Turn the empty toner cartridge (1) clockwise by approximately 180 degrees
until it is fully unlocked.
S
Remove the toner cartridge.
S Shake the new toner cartridge several times.
S Insert a new toner cartridge approximate 10 cm, illustrated below, with the
attached plastic seal (3) pointing to the top.
S Remove the stripe (4) from the cardboard roll (5) and fix it at the begin of the
plastic seal tape (3) .
S Turn the cardboard roll (5) to roll up the plastic seal (3) until the seal is
entirely removed and push the toner cartridge until it is fully inserted.
S
Turn the toner cartridge (1) counter clockwise by about 180 degrees until it
is fully engaged.
Note:
The cover of the toner cartridge (1) must be locked by the screw (6).
S
Close the front cover (21).
Note:
Don´t refill the toner of the Waste Toner Bottle into the Toner Cartridge!