I
Safety Regulations for the Laser Printer PP 4x50 and
PP 4050XP and the intelligent Paper Stacker iPS 4050E
The LED printers
PP 4050
,
PP 4050MICR
,
PP 4050XP
,
PP 4650
and the
intelligent Paper Stacker iPS 4050E
fulfils the safety regulations according to
IEC, VDE/GS, and UL / C-UL for information technology equipments (EN 60950,
UL 1950 3rd Edition / CAN/CSA C22.2 No 950-95).
Note:
The commercial name of the
iPS 4050E
is
iPS 4050/4060
).
The mains cable must be connected to a ground protected wall-socket. The
printer's voltage has to be in accordance with the local mains voltage.
The power plug must be easily accessible at any time so that it can be
disconnected immediately in case of danger or for maintenance purposes.
Before installing the printer, check the surrounding conditions in which the
printer is intended to be used (see next page, Operating Environment).
During thunderstorm you should never attempt to connect or disconnect any
data transfer cable.
The power supply should only be opened and checked by authorized personnel.
Maintenance beyond the descriptions of chapter 5 may only be attempted by
authorized personnel. Repairs done inappropriately may seriously jeopardize
the user's safety.
Attention:
This symbol is standing for a hot surface -
danger
of burning!
Safety Regulations
II
Electromagnetic Compatibility
We certify that the equipment at issue,
Type:
Printer PP 4050
,
PP 4050MICR
,
PP 4050XP
,
PP 4650
and the
intelligent Paper Stacker iPS 4050E
corresponds to the laws and regulations ruling electromagnetic compatibility of
appliances (89/336/EWG) and, therefore, fulfils the requirements for conformity
marking with the CE-sign.
To guarantee that the device stays within the limits according to the approval
regulations for conducted and radiated emission (EN 55022, Class B) and
immunity (EN 55024) in any case shielded interface cables are to be used only.
Note:
This equipment has been tested and found to comply with the limits for a
CLASS A
digital device pursuant to
Part 15
of the
FCC
Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in wich case the user will be required
to correct the interference at his own expense.
Changes and modifications not explicitly allowed by the equipment's
manufacturer could void the user's authority to operate the equipment.
Operating Environment
Avoid installing the printer where it is exposed to moisture or heat (eg. direct
sunlight).
The printer is designed to operate in a wide range of environmental conditions.
S
Temperature: + 15°C to + 35°C (+59°F to + 95°F)
S
Humidity:
30% to 50%
For best performance, store and use fanfold paper at 19
E
to 23° C (68° to 73°F)
and a relative humidity of 33 to 47 percent.
Note:
In case of higher values for temperature and humidity the print quality
will degrade!