Installing the Printer and the intelligent Paper Stacker
1-19
1.7
Power ON/OFF Switch
S
Connect the printer to the mains using the power cord (14).
S
The power ON/OFF switch (15), can be found in the housing under the lower
tractor cassette to the rear of the printer, switches the printer's power supply
ON or OFF.
When switched
ON
the printer performs an internal self test which checks the
electronics, fans, and the motors for the paper transport mechanism.
The display (17) presents the message:
MEMORY TEST!
PLEASE WAIT ...
After successful completion two messages pop up shortly after each other:
OFFLINE (1)
..................
..................
PCL
Then all fields of the display will show black squares and a short beep sounds;
power
ON
is indicated by a green LED (16).
Installing the Printer and the intelligent Paper Stacker
1-20
The following message appears:
ONLINE (1)
..................
..................
02 WARMING UP
After a short delay the message
WARMING UP
in line 4 will disappear.
Note:
If an arror message is displayed please refer to section 6.2
Error
Messages
.
1.8
Handling the Tractor Cassettes
The printer has two tractor cassettes for fanfold paper, the
LOWER
TRACTOR
cassette and the
UPPER TRACTOR
cassette. The tractor cassettes
are in the Starter Kit Package 1 and 2
If the printer is used without the intelligent Paper Stacker, align the printer with
the front edge of the table. Ensure that the cables at the paper exit do not block
the paper path.
Simply slide the tractor cassettes forward into the respective guides (see
illustration). Remove the tractor cassettes by lifting and pulling them toward you.
Take out the
UPPER TRACTOR
before inserting paper into the
LOWER
TRACTOR
. If more than two different fanfold papers are to be processed, it is
useful to work with additional tractor cassettes. Such an additional tractor
cassette can be preloaded with paper and quickly mounted into the printer as
required.