Printronix L5535, Maintenance Manual

Page: 351 / 358

II–351
global memory adjust, I–104
printer control, I–105
Message table, error messages, I–116
Messages
CLEARING PROGRAM / FROM FLASH, I–117
DIAGNOSTICS / PASSED, I–117
ERROR
DC PROGRAM / NOT VALID, I–117
DRAM AT / ADDRESS xxxxxxxx, I–117
FLASH / DID NOT PROGRAM, I–118
FLASH / NOT DETECTED, I–118
FLASH TYPE / IS NOT SUPPORTED,
I–118
NO DRAM / DETECTED, I–118
NVRAM / FAILURE, I–118
PROGRAM / NEEDS MORE DRAM, I–119
PROGRAM / NEEDS MORE FLASH,
I–119
PROGRAM / NOT COMPATIBLE, I–119
PROGRAM / NOT VALID, I–119
SECURITY PAL / NOT DETECTED, I–119
SHORT AT / ADDRESS xxxx, I–119
WRITING / TO FLASH, I–119
WRONG / CHECKSUM, I–120
ERROR OCCURRED / FLUSHING QUEUES *,
I–117
FILE EXISTS / ENABLE OVERWRITE, I–120
FILE SYS FULL / ADD FLASH, I–120
FILE SYS FULL / DELETE FILES, I–120
FILE SYS FULL / OPTIMIZE&REBOOT, I–120
FILE SYS INVALID / OPTIMIZE&REBOOT,
I–120
FILE SYS WRITE / CHECK FLASH, I–121
INSUFFICIENT RAM / REBOOT/ADD RAM,
I–121
LOADING FONTS, I–121
LOADING PROGRAM / FROM PORT xx%,
I–121
LOADING PROGRAM / INTO FLASH, I–121
OPTIMIZING / FLASH FILES, I–122
RESETTING... / PLEASE WAIT, I–122
SECURITY CODE / VIOLATION, I–122
service level, clearing, I–69
STANDBY..., I–122
TESTING HARDWARE / PLEASE WAIT, I–122
TRAY MISMATCH, I–117
WAITING FOR / PROGRAM DOWNLOAD,
I–122
Mnemonics, interconnection diagram, II–176
Motor
cutter, I–284
drum, I–285
feed (FMT), I–289
feed encoders (FME 19/20), I–289
magroll (MRM), I–287
magroll, MC board, I–212
sleeve (SLM), I–287
sleeve, MC board, I–212
tractor/drive belts, I–292
transfer elevator, I–296
Motor rotation control, theory, II–145
Motors
cut-sheet paper feed motor, theory, II–146
cut-sheet paper pickup motor, theory, II–146
drum motor, theory, II–146
main unit feed motor, theory, II–146
perforation cutter motor, theory, II–151
power paper stacker, II–315
tractor motor, theory, II–147
transfer elevator motor, theory, II–149
N
Nip switch (NPSW), sensors/switches, I–327, I–329
No Cleaning Unit (Error 26), I–153
No Paper Cassette (Error 66), I–164
No Waste Toner Box (Error 29), I–154
NVRAM values, MC board, I–206
O
Operational sequences, II–159
OPTIMIZING / FLASH FILES, I–122
Options
cut sheet feeder, II–235
power paper stacker, II–263
Output roller drive belts, I–307
Output section, transport, paper jams in, I–114
P
Page counter software, I–69
Page counts, service levels, I–68
Paper
detection, theory, II–124
feed section, theory, II–124
jams, detection sensors
See
Jam detection sensors, I–101
loading
cut-sheet, I–57
fanfold, I–55
theory, II–126