4.2.3
Step Mode
Step Mode
allows the user to simulate Step changes of output voltage/current.
Refer to Figure 4.13 and perform the followings to build a Step test:
1.
Select to perform
Voltage Step testing
(click the icon
) or
Current
Step testing
(click the icon
).
2.
Set
voltage
/
current
and
dwell time
for each step in
Step Set List
.
3.
Set the start number of Step set in
Start NO.
, end number of Step set in
End NO.
and the number of times the entire sets is repeated in
Cycle Times
.
4.
After all the settings are completed, click
ON
to start the output.
Figure 4.13 Step mode (output OFF)
When the output is started, this section displays the current cycle in
Loop Times
and
elapsed time in
Test Time
as shown in Figure 4.14. The output stops when the testing
cycle ends or by clicking
OFF
.
Figure 4.14 Step mode (output ON)