3.6.1
Step Setting Page
After entering into the Step Setting page (refer to Figure 3.10), first, select the testing
mode to be programmed, the
Voltage step testing
(press the icon
) or
the
Current Step testing
(press the icon
). Then, program the following
parameters: output
voltage
/
current
and
dwell time
for each Step Set at the left area;
start number
and
end number
of Step Set and
cycle times
at the right area. After
finishing the setting above, press the icon
to enter the Step Performing
page.
(a)
Voltage Step setting
(b)
Current Step setting
Figure 3.10 Step setting page
The descriptions for the items and the icons in the above figure are given as follows.
Displays the number of Step Set (up to 24 sets)
Sets the output voltage of Step Set in volts
Sets the output current of Step Set in amps
Sets the dwell time of Step Set (Hour/Minute/Second)
Scrolls up the list of Step Set
Scrolls down the list of Step Set
Sets the start number of Step Set
Sets the end number of Step Set