PowerBoss Admiral 48D, Instruction Manual

Page: 36 / 120

36
Operation
The basic vehicle can be supplemented
by further components. The order and
spare parts numbers of these
components are in brackets.
Please refer to our spare parts
catalogue in Internet under
www.powerboss.com for
information on accessories
such as brushes, pads, drive
plates with centerlock etc.
• Working lights
(Fig. 18/1) (7584.02)
Area of use: To enable use of the
vehicle even in badly lit areas.
• Cab safety roof
(Fig. 18/2) (7582)
Area of use: To protect the driver,
e.g. from parts which could fall from
high rack warehouses. Including
rear-view mirror.
Pay attention that assembly of
a cab safety roof is made
compulsory when the vehicle is
operated in such risk areas.
• Flashing beacon
(Fig. 18/3)
(7585.02 Assembly on cab safety
roof)
(7585.10 Assembly on pole / without
cab safety roof)
Area of use: To improve awareness
of the vehicle when in use.
• Spray/Vacuum tool
(Fig. 18/4)
Area of use: Areas which are difficult
to access can be cleaned manually
with a spraying and vacuuming tool.
A holder can be installed on the left-
hand side of the vehicle to fix the
spray/vacuum tool. Two holes are
already drilled in the left-hand side of
the vehicle for this. The following
belong to the spray/vacuum tool:
-
Floor scrubbing tool (7009)
- Suction and spraying hose
(7766)
- Tool holder and attachment
parts
(7311.10)
The corresponding buttons are
provided on the left operating panel
with which to
operate the
spray/vacuum tool :
- Vacuuming tool on/off switch:
Press the button to switch the fresh
water supply on and off
(Fig.
21/14).
- Press the reduce fresh water
quantity button (Fig. 21/13) or
increase fresh water quantity
button (Fig.
21/15) to set the
required water quantity, also refer
to Section "Keypad to control the