PowerBoss Admiral 48D, Instruction Manual

Page: 111 / 120

111
Maintenance and Service
5.10 Wheels
The wheel nuts on the wheels
(Fig.
44/1) must be subjected to their
first check after 100 operating hours
and subsequently every 200 hours.
The tightening torque for the
wheel nuts (Fig.
44/1) is
103.3 lb ft.
Fig. 44
5.10.1 Changing the rear wheels
1. Jack up the scrubber-drier on the left
or right side: The contact points for
the jack (lifting power: 2.0 t) are on
the frame in front of the rear wheels.
2. Remove the wheel nuts (Fig. 44/1).
3. Pull off the wheel (Fig. 44/2).
4. Fit a wheel (Fig. 44/2).
5. Screw on and tighten the wheel nuts
(Fig. 44/1).
5.10.2 Changing the front wheel
The procedure to change the front
wheel is analog to changing the rear
wheels:
1. Apply the jack at the front centered to
the vehicle's front frame and jack up
the scrubber-drier.
2. Unscrew the wheel nuts.
3. Remove the wheel.
4. Install the wheel in place.
5. Screw on and tighten the wheel nuts.
1
2