PowerBoss Admiral 48D, Instruction Manual

Page: 59 / 120

59
Operation
Check whether the floor is
sufficiently dry at regular
intervals, otherwise people
could slip. If the floor is
excessively wet, check the
vehicle for leaks and that the
sealing strips are in a good
condition. If the sealing strips
are damaged, change them;
refer to Section 5.8.4. Wet scrubbing (basic cleaning)
If you do not want to vacuum the floor
dry in the same working procedure
because you want the solution to soak
into the dirt, for example, activate this
program.
Wet floors are a potential risk
for slipping! Ensure to provide
the corresponding information
and warning signs.
• Press the “Button for the
brush drive” (Fig. 21/9)
on the left-hand operating
panel.
Various functions can be
switched on or off with the following
buttons according to the conditions at
the location of use:
• Reduce water quantity (Fig. 26/2)
• Increase water quantity (Fig. 26/4)
• Fresh water feed on/off (Fig. 26/3)
• Increase brush pressure (Fig. 26/1)
Vacuuming dry
• Press the “Button for
squeegee and suction
turbine” (Fig.
21/10) on
the left-hand operating
panel.
Check whether the floor is
sufficiently dry at regular
intervals, otherwise people
could slip. If the floor is
excessively wet, check the
vehicle for leaks and that the
sealing strips are in a good
condition. If the sealing strips
are damaged, change them;
refer to Section 5.8.4.