Potter UDACT-9100, Installation And Operation Manual, Page: 24 / 36

Configuration & LCD Operation
20
2. Telephone Line Menu
3. Report Options Menu
Command Menu/Dialer-Config/Telephone Line
1. Line#1 Dialing Type
[X] DTMF Dial->Def
[ ] Pulse Dial
Set the dialing type for line #1
DTMF is the type recognized or
preferred by the telephone
company.
Command Menu/Dialer-Config/Telephone Line
2. Line#2 Dialing Type
[X] DTMF Dial->Def
[ ] Pulse Dial
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
3. Line#1 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Use this function to let the system
know whether or not to wait for a
dial tone before dialing.
Command Menu/Dialer-Config/Telephone Line
4.Line#2 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Same as Line#1.
When a wireless or cellphone
service is employed, it could be
connected with Line2 interface
only. The dial-tone detection should
be disabled.
Command Menu/Dialer-Config/Telephone Line
5.Number of retries
06 ->Default
Set the number of retries for both
line#1 and line#2. This function
lets the dialer retry on either line
if it is busy or not available. If the
retry count expires, the panel
reports a line trouble.
1 L i n e 1 D i a l t y p e
2 L i n e 2 D i a l t y p e
3 L i n e 1 D i a l t o n e
4 L i n e 2 D i a l t o n e
- T e l e p h o n e L i n e -
5 N u m o f R e t r i e s
L i n e # 1 D i a l i n g T y p e :
[ X ] D T M F D i a l
L i n e # 2 D i a l i n g T y p e :
[ X ] D T M F D i a l
L i n e # 1 W a i t D i a l t o n e
[ X ] E N A B L E
L i n e # 2 W a i t D i a l t o n e
[ X ] E N A B L E
N u m b e r o f R e t r i e s :
0 6
1 Alarm Prio.
2 Trouble Prio.
3 Supv. Priority
4 Aux Dis Report
- Report Options -
5 Fire Panel
6 Operation Mode
7 Checksum Bits
- Report Options -
1 Alarm Prio.
2 Trouble Prio.
3 Supv. Priority
4 Ignore Supervisory
5 Fire Panel
6 Operation Mode
7 Checksum Bits
Protocol
firealarmresources.com