Potter UDACT-9100, Installation And Operation Manual, Page: 21 / 36

UDACT-9100 Dialer Installation and Operation Instructions
17
7. Set Password (Command-Menu)
8. Default Config (Command-Menu)
Command Menu/Set Password
If the passcode does not match, the
following message appears and the
system exit to the main menu
If the passcode is OK the following
message appears and exits to the main
menu
1111 -> Default
Use this function to
change the passcode.
The minimum number of
digits is 4 and the
maximum number is 10.
ONLY numeric digits are
allowed.
Command Menu/Default Config
Press “UP” and “DOWN” to select
between Y/N. if “ENTER” is pressed the
default configuration is restored.
Use this function to load the default configuration in
the panel.
Warning: By loading default configuration all the
previously programmed configuration is lost
permanently.
Enter new passcode
_
Re-enter passcode
_
i n v a l i d p a s s c o d e
P a s s c o d e u p d a t e d
L o a d t h e d e f a u l t
s e t t i n g s ? Y
D e f a u l t s e t t i n g s
h a v e b e e n l o a d e d
firealarmresources.com