Potter UDACT-9100, Installation And Operation Manual, Page: 17 / 36

UDACT-9100 Dialer Installation and Operation Instructions
13
3. Test Dialer (Command-Menu)
Dialer Test Messages
The following messages will display during the test processes of Lines #1 and #2. The messages that will appear
depend on the status of the dialer and the test results that are found.
Press Enter to test Line #1. Press Cancel to exit
this menu. For a description of test messages,
see
Dialer Test Messages on the following page.
Press Enter to test Line #2. Press Cancel to exit
this menu. For a description of test messages,
see
Dialer Test Messages on the following page.
This feature flushes all reportable events from
the buffer, clears all dialer troubles and resets
the dialer operation. Press Enter to reset the
dialer. Press Cancel to exit this menu.
The dialer is checking the line for voltage. This
message automatically displays when Manual
Test is selected.
No DC line voltage. The line is dead or no phone
line is connected or the phone line operates at
abnormal voltage.
The dialer is waiting for a dial tone.
This message may indicate a noisy telephone
line.
The dial tone was detected and telephone number
dialing is in process.
This message indicates that the dialer failed to
send a DTMF tone.
Waiting for availability of the receiver. The
receiver confirms the availability by sending an
Ack tone.
- D i a l e r T e s t -
1 . L # 1 M a n u al t e s t
2 . L # 2 M a n u al t e s t
3 . R e s e t Di a l e r
1 . L # 1 M a n u a l t e s t
2 . L # 2 M a n u a l t e s t
3 R e s e t D i a l e r
.
D i a l e r i d l e n o w
N o D C V o l t
W a i t i n g f o r D i a l t o n e
F a i l e d : N o D i a l t o n e
D i a l i n g R e c e i v e r N o w
N o D T M F t o n e
W a i t i n g f o r A c k t o n e
firealarmresources.com