Potter UDACT-9100, Installation And Operation Manual, Page: 14 / 36

Configuration & LCD Operation
10
Configuration & LCD Operation
The following shows the configuration at the UDACT-9100 using the keypad and the CFG-LCD Configuration Tool.
The Potter Digital Communicator is configured by connecting the cable of the
CFG-LCD Configuration Tool to the
U18 connector on the UDACT-9100 Main Board and placing the LCD over the 3 standoffs as shown in Figure 2.
In order to configure the UDACT-9100, place a jumper on JW2, remove once configuration is complete otherwise
there will be a trouble message.
To access configuration mode press the Menu button on the front panel display . The CFG-LCD will display
the Main Menu. The keypad on the UDACT-9100 board and the CFG-LCD is shown together in Figure 4 , below.
Figure 4: UDACT-9100 Configuration
(17(5
0(18
&$1&(/
,1)2
$%& '()
*+, -./ 012
356
789 :;<
4=
23
#/--/.
42/5",%
#05
&!),
,).% ,).%
0/7%2
/.
6<67(01250$/
021
UDACT (Prot-1) Idle
20:00 SUN 2006-10-1
firealarmresources.com