Polycom V500, Administrator'S Manual, Page: 16 / 146

Administrator’s Guide for the V500 System
2 - 4
Connecting Headphones
You can connect headphones to the V500 system to listen to your calls
privately.
The back panel view on page
2-1 shows the location of the headphone jack.
Installing Batteries in the Remote Control
The remote control uses three AAA batteries, which are included with the
system.
To install batteries in the remote control:
1.
Remove the battery cover from the back of the remote control.
2.
Refer to the diagram inside the remote control, and install the batteries in
the orientation shown.
3.
Reinstall the battery cover on the remote control.
The system notifies you when the batteries need to be replaced.
Powering On the System
The V500 system has an external power supply.
The back panel view, shown on page 2-1 , shows the location of the power
connector and power switch.
To power on the system:
1.
Make sure you have connected all equipment to the system, and then
connect the power cord to a wall outlet.
2.
Power on the monitor.
3.
Press the power switch located at the back of the system.
Do not use a power supply other than the one supplied with your V500 system.
Using the wrong power supply will void the warranty and may damage your system.