P. 26
Installation
Guide
PS-4660TW
If option
Ignition Unlock Only
is selected, the system will
UNLOCK
all Doors when the key
is turned to the
OFF
position (provided that the Ignition key was in the
IGNITION ON (RUN)
position and that the Brake Pedal was pressed at least once).
Secure Lock
This feature allows the Remote Car Starter to control certain OEM factory Alarm systems
without requiring the use of other wires for disarming the OEM Alarm. (Namely, this
feature is designed for OEM systems which use the factory Lock wire to
arm
the Alarm
and the Unlock wire to
disarm
it.)
Standard Secure Lock
If this Option is selected, upon receiving a remote
START
signal, Secure Lock will
UNLOCK
the Doors (disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will
re-
lock
the Doors. 4 seconds after shutdown, Secure Lock will
re-lock
all Doors (
arming
the system once again).
Please note
that most OEM systems will
not
rearm the Alarm
while the Engine is running, but
will still lock the Doors.
Smart Secure Lock
If the vehicle is initially locked, upon remote
START
the Remote Car Starter will trigger an
unlock pulse
and a
disarm pulse
before the Engine is started. The Remote Car Starter
will
LOCK
again when the Engine is running, and
LOCK
once again 4 seconds after shut-
down.
If the vehicle is initially
unlocked
, upon remote
START
the Remote Car Starter will start
the Engine and arm the Starter Kill, but the Doors will not be locked or unlocked at any
moment of the sequence.
Lock Pulse Duration
The duration of the Lock and Unlock pulses can be configured as follows:
•
(Default) 7/10-sec.
LOCK
and 7/10-sec.
UNLOCK
pulses
•
4-sec.
LOCK/UNLOCK
pulses to control vacuum Door Lock systems
•
A
single 7/10-sec.
LOCK
pulse and
two 1/4-sec.
UNLOCK
pulses
for double-pulse disarm/unlock systems.
•
1/10-sec.
LOCK
and 1/10-sec.
UNLOCK
pulses
Engine Run Time
Use this Function to configure the length of time the Engine will be left running under
remote control. The Remote Car Starter will allow the Engine to run for either
4, 15 or 25
min. in Gas Mode and
9, 20 or 30
min. in Diesel Mode. Standard default Run Time is 15
minutes in Gas mode and 20 minutes in Diesel mode.
Starter Kill (Installation)
The Remote Car Starter is equipped with a selectable
Passive
or
Active-arming Starter
Kill
circuit that will prevent the vehicle from being started with the Ignition Key when the
Remote Car Starter is armed. The Starter Kill wire will provide a constant 500-mA.
negative output when the system is
armed
(locked by remote control) and can be
connected to an external Starter or Ignition interrupt relay (see diagram below).
The Starter Kill circuit can be set to arm in either
Passive Mode
or
Active Mode
