P. 20
Installation
Guide
PS-4660TW
If order to carry out Tach Programming, you may simply follow the Automatic Tach
Programming procedure.
The Remote Car Starter stores Tach settings regardless of the procedure used at the
time of Tach programming. All Tach settings are cleared when the Remote Car Starter is
reset. A new Tach Programming procedure has to be carried out
only
if the Remote Car
Starter is reset.
Multi-speed Tach Programming
Tach signals may vary from vehicle to vehicle. The
Remote Car Starter is designed to
read a wide range of Tach signals produced by recent Ignition systems. There is no
necessary manual adjustment. Nevertheless, a Tach-programming procedure
must
be
carried out
every time a new Remote Car Starter Unit is installed
. This is because the
Tach signals of certain Ignition systems are sometimes too low or too high for the
Remote Car Starter, causing failed start-ups at various temperatures.
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out:
2.
Press and hold the
Brake Pedal
,
– And simultaneously press the
LOCK
and
UNLOCK
buttons on the Transmitter:
– The Parking Lights will flash 4 times.
– Release the Brake Pedal.
3.
Start up the Engine
and allow the vehicle to reach regular Engine idle speed.
4.
Once the Engine is running idle, press the
Brake Pedal
and keep it down until you
hear the Parking Lights Output flash 5 times.
– Release the Brake Pedal: Tach Programming is now complete.
Table 7
Note
The L.E.D. follows the Parking Lights during the
Transmitter Programming procedure.
At any time, close the Hood to end the Tach-
programming procedure.
Automatic Tach Programming
This simple procedure can replace the Multi-speed Tach Programming procedure:
1.
Make sure that all the connections are properly made and that the Remote Car
Starter is powered up.
2.
With the Hood up (ground on the Hood Pin switch line), start the vehicle using the
Key.
3.
Allow the vehicle to reach regular Engine idle speed.
The Parking Light output from the Remote Car Starter will activate when the
vehicle starts and shut off once a Tach signal is detected.
4.
Press the
Brake Pedal
and keep it down until you hear the Parking Lights Output
flash 5 times.
5.
Shut down the Engine. Tach Programming is now complete.
Table 8
